How to Unclog a Bathtub Drain With Standing Water

At some point, you’re bound to notice that the bathtub drain has a lot of standing water. It’s time to take action and do something about it. Here’s how you can unclog a bathtub drain with standing water the natural way.

Why Does Your Bathtub Drain Clog?

There are a few things you can do to try and unclog a bathtub drain with standing water: use a plunger, pour a pot of boiling water down the drain, use a vacuum cleaner with the hose attachment, or use a chemical drain cleaner. Discover diy concrete pool.

If none of these work, then you may need to call a plumber. Clogged drains can cause flooding and damage to your home. One of the most common reasons your bathtub drain might become clogged is because of accumulated soap and water. When the tub fills up with water, it can be difficult for the drain to drain properly. Additionally, if water accumulates in the bathtub over time, it can cause roots to grow in the drainage system and block flow. In some cases, a build-up of hair or other debris can also cause a blockage. If you notice that your bathtub drain is becoming slower to drain, there are a few simple steps you can take to unclog it.

How to Unclog a Bathtub Drain With Standing Water

If you have a bathtub that’s constantly filling up with water and unable to drain, it might be time to call a professional. Here’s how to unclog a bathtub drain with standing water:

1. Turn off the main water valve in your home. This will stop the flow of water into the bathtub.

2. Remove any excess water from around the bathtub drain using a plunger or snake. Make sure to push down on the plunger or snake from above so that the suction can pull debris out of the drain. Keep clearing away debris until no more comes out.

3. Open the bathtub drain cover by unscrewing it (it has a wing nut on one side). The cover should now be able to move freely in both directions. If it’s difficult to open, use a bucket to hold down one side while you loosen the wing nut with your fingers. Once loosened, carefully remove the cover and set it aside. Get info about elephant decor.

4. Use a wire brush or plunger extension tube to clear debris and debris obstructions lodged in the bathtub drain area. Be sure to push down on the brush or tube from the inside of the pipes to avoid dislodging debris you have removed.

5. After clearing debris and debris obstructions, use a funnel to fill the bathtub drain hose with pipe cleaner.

6. Place a bucket under the bathtub drain hose and open it wide, letting it hang over the sink or tub rim.

7. Insert pipe cleaner into the bottom of the barrel and place a light coat (about an inch) on one end into your hand (the bowl end). Use two fingers to squeeze out extra pipe cleaner from the barrel using that first finger as a stirrer.

8. With your other hand, add pipe cleaner as needed until only a couple inches remain in the bottom of the barrel and place it back into the bathtub drain hose.

9. Re-insert the water supply hose into the faucet and turn on the water until water begins to flow through. Wait a few minutes and then shut off the water supply to the faucet and remove the pipe cleaner from between your two hands.

10. Slide the pipe cleaner up over the end of the nozzle (8 inches, if you have a high-end sink) and then release it carefully by gently pulling it out of your hand as it exits, while at the same time gently pushing down with your hand on top of it to push it through, just like a tampon, without ripping or tearing anything. Find out germinating seeds in paper towel.

Natural Ways to Unclog a Bathtub Drain With Standing Water

If you’re experiencing problems with your bathtub draining, there are a few natural methods you can try before calling a professional.

1. Pour a pot of boiling water into the bathtub and wait two minutes. Pour a pot of cold water into the bathtub and wait two minutes. Drain both pots of water.

2. Use a plunger to remove as much water as possible from the bathtub drain using long, smooth strokes. Be sure to avoid touching the drain itself; use the plunger’s suction to push the water away from the drain. Continue pumping until all of the water has been removed.

3. Add baking soda to a bucket or bowl and fill it three-quarters of the way with warm water. Swish the baking soda mixture around in the bucket for about 30 seconds, then pour it down the bathtub drain. Be sure to hold onto the bottom of the drain while pouring in order to keep debris from entering the plumbing system. Wait 10 minutes before using the bathroom. Look at the ceiling decorations.

4. Mix 1 cup of white vinegar and 3 cups of hot water in a large bowl and pour it down the bathtub drain. Let it sit for 10 minutes, then flush the drain. Repeat this once every five days until the clog is removed.